Abstract This study was investigated the effects of hot-air temperature and slice thickness on drying characteristics of Crabapple slices. Drying experiments were carried out in the ranges of 60-90 °C. The thickness conditions of Crabapple slices for thin layer drying were 3mm and 5mm. The increase in the temperature of the hot-air and the decrease in the thickness of the slicing causes the drying time to be significantly shortened. Fick’s diffusion model was applied to describe the water transfer of the Crabapple slices, and the effective diffusion coefficients varied from 0.6142 × 10-8m2/s to 1.9867 × 10-8m2/s in a given range of drying temperature. The effective diffusivity increases with increasing temperature. The activation energy values of Crabapple were 17.46 and 23.82 kJ/mol for the thickness of 3 and 5 mm, respectively. The Page model was revealed to be a better fit to describe the drying curve of Crabapple compared to other models.

Abstract Total flavonoids were extracted from Ziziphi Spinosae Semen (ZSS) by applying microwave-assisted extraction with low eutectic solvent (DES) as the extractant. This study investigated the effect of 21 different components of DES on the yield of total flavonoids in ZSS. The results revealed that the DES system, which consists of choline chloride and lactic acid with a molar ratio of 2:1, achieved the best flavonoid extraction efficiency. Based on the single-factor test, response surface methodology was used to optimize and determine the optimal process conditions for the extraction of total flavonoids from ZSS with deep eutectic solvent. The maximum flavonoids yields were achieved at 36.24 mg/g within the 50% DES water content, a microwave power of 600 W, a microwave time of 60 s, a liquid-solid ratio of 1:28 mg/mL, an extraction time of 66 min, and an extraction temperature of 93 °C. The macroporous resin was used to recover flavonoids from extracts. The DM130 resin showed higher adsorption/desorption performance. The total flavonoids of ZSS were extracted using the recovered DES with a yield of 32.58 mg/g and a high reusability of 89.9%.

Abstract In this study, the effects of ethanolic extract from onion skin (EEOS) on the storage quality of refrigerated beef patties were studied. EEOS concentrations of 0.00%, 0.01%, 0.05%, and 0.10% were added to beef patties. These beef patties were stored at 4 °C for 12 days and compared with 0.05 VC treatment group. At the end of storage, compared to control, 0.1% EEOS effectively reduced the contents of metmyoglobin (MetMb) (P < 0.05) and thiobarbituric acid reactants (TBARS) (P < 0.05) in beef patties by 30.89% and 44.72%, respectively. On day 12, the carbonyl contents in 0.1% EEOS treatment increased only 3.3 times, lower than control and VC treatment (4.5 and 4.1 times). Microbial contamination was significantly inhibited (P < 0.05). The antioxidant and antibacterial effects of EEOS were the main reasons for the improvement of pH and a* stability of beef patties. However, the addition of EEOS had no significant effect on cooking loss and texture properties except hardness and springiness. Overall, 0.1% EEOS had a positive effect on the sensory characteristics and storage quality of beef patties and could prolong the storage life of beef patties to 9 days. This showed that EEOS as a natural additive has great potential for beef storage and preservation.

Abstract This study investigated the effects of temperature on the drying behavior and kinetic features of lily scales. A series of experiments were carried out at 65, 75, and 85 °C to dry the scales in a laboratory air-ventilated oven dryer. Drying temperature was found to significantly affect drying times and drying rates. The rate curves suggested that the drying process of lily scales occurred entirely within the descending rate period. During the simulation of drying kinetics, Page and Logarithmic models were proven highly accurate by evaluating the efficacy of seven different thin layer models. Based on Fick’s second law, the effective moisture diffusivity was determined as 4.12 × 10−9, 7.71 × 10−9, and 9.49 × 10−9 m2/s for temperatures of 65, 75, and 85 °C, respectively. The calculated figure of activation energy was 42.42 kJ/mol.